Home | Engineering | Angle Dekkor

Mechanical - Metrology and Measurements - Linear and Angular Measurements

Angle Dekkor

   Posted On :  23.09.2016 01:55 pm
Angle Dekkor

This is also a type of auto-collimator. There is an illuminated scale in the focal plane of the collimating lens.

ANGLE DEKKOR

 

 

 

This is also a type of auto-collimator. There is an illuminated scale in the focal plane of the collimating lens. This illuminated scale is projected as a parallel beam by the collimating lens which after striking a reflector below the instrument is refocused by the lens in the filed of view of the eyepiece. In the field of view of microscope, there is another datum scale fixed across the center of screen. The reflected image of the illuminated scale is received at right angle to the fixed scale as shown in fig. Thus the changes in angular position of the reflector in two planes are indicated by changes in the point of intersection of the two scales. One division on the scale is calibrated to read 1 minute.

 


 

 

Uses of Angle Dekkor

 

 

(i) Measuring angle of a component

 

 

 

Angle dekkor is capable of measuring small variations in angular setting i.e. determining angular tilt. Angle dekkor is used in combination with angle gauge. First the angle gauge combination is set up to the nearest known angle of the component. Now the angle dekkor is set to zero reading on the illuminated scale. The angle gauge build up is then removed and replaced by the component under test. Usually a straight edge being used to ensure that there is no change in lateral positions. The new position of the reflected scale with respect to the fixed scale gives the angular tilt of the component from the set angle.

(ii) Checking the slope angle of a V-block

 

Figure shows the set up for checking the sloping angle of V block. Initially, a polished reflector or slip gauge is attached in close contact with the work surface. By using angle gauge zero reading is obtained in the angle dekkor. Then the angle may be calculated by comparing the reading obtained from the angle dekkor and angle gauge.

 

(iii) To measure the angle of cone or Taper gauge

Initially, the angle dekkor is set for the nominal angle of cone by using angle gauge or sine bar. The cone is then placed in position with its base resting on the surface plate. A slip gauge or reflector is attached on the cone since no reflection can be obtained from the curved surface. Any deviation from the set angle will be noted by the angle dekkor in the eyepiece and indicated by the shifting of the image of illuminated scale.


Tags : Mechanical - Metrology and Measurements - Linear and Angular Measurements
Last 30 days 949 views
Related words :

What is Angle Dekkor Define Angle Dekkor Definition of Angle Dekkor where how meaning of Angle Dekkor lecturing notes for Angle Dekkor lecture notes question and answer for Angle Dekkor answer Angle Dekkor study material Angle Dekkor assignment Angle Dekkor reference description of Angle Dekkor explanation of Angle Dekkor brief detail of Angle Dekkor easy explanation solution Angle Dekkor wiki Angle Dekkor wikipedia how why is who were when is when did where did Angle Dekkor list of Angle Dekkor school assignment college assignment Angle Dekkor college notes school notes kids with diagram or figure or image difference between Angle Dekkor www.readorrefer.in - Read Or Refer

​TOP MENU

OTHER SUGEST TOPIC